27. giugno 2012

5-pin circuit board adapter Han®

5-pin circuit board adapter Han®

Creation of a multi-pin connector as printed circuit board connection

By combining the new 5-pin HARTING circuit board adapter with a Han® DDD module from the proven Han-Modular® series, it is now possible to create a multi-pin connector on a device’s printed circuit board. The circuit board adapter can be pre-assembled on the PCB by following the hole pattern. A 17-pin circuit board connection is created for the Han® DDD module through connection of two 6-pin and the new 5-pin circuit board adapter. Here, the adapter can be assembled onto the PCB independently of the connector. After assembly of the PCB, the male or female contact of the Han® DDD module is installed in the housing and attached on the pre-assembled PCB. Simple assembly is not the only advantage – the labor involved in wiring is also kept to a minimum.

For connection to the circuit board, 17 contacts are available, with the following technical rated values as per DIN EN 61984:

  • 7.5 A rated current
  • 160 V rated voltage
  • 2.5 kV rated surge voltage at pollution grade 3


With this, the HARTING Han-Modular® series expands the product portfolio by a further variety of PCB adapter as well as the existing Han® DD solutions and the Han® 40 A module.
With the open Han-Modular® connector system, the user can assemble a connector to his own individual requirements. This provides over 40 different modules for electrical, optical and pneumatic transmissions.

Download disponibili:

data sheet 5-pin circuit board adapter Han®

data sheet

PDF

382 K download